DELL EMC D-PEMX-DY-23 Übungsprüfungen
Zuletzt aktualisiert am 25.04.2025- Prüfungscode: D-PEMX-DY-23
- Prüfungsname: Dell PowerEdge MX Modular Deploy 2023 Exam
- Zertifizierungsanbieter: DELL EMC
- Zuletzt aktualisiert am: 25.04.2025
During the installation of a PowerEdge MX7000, the implementation engineer notices the PSU health indicator stay on for one second, blink five times, then shut off.
What is the issue?
- A . The PSU is faulty.
- B . There is a PSU mismatch.
- C . The PSU is performing firmware updates.
- D . There is no power to the PSU.
An administrator is connecting two MX840c to an MX5016s. The MX5016s is configured in Enclosure Assigned mode.
What should the requirements of this mode be to avoid configuration issues?
- A . MX745P with a cluster aware OS
- B . MX745P with no OS restrictions
- C . HBA330MMZ with no OS restrictions
- D . HBA330MMZ with a cluster aware OS
In SmartFabric mode, what is the recommended maximum number of VLANs per server port on an MX7000 switch?
- A . 256
- B . 512
- C . 1024
- D . 1536
Which three components store an MX7000 chassis service tag and MAC address configuration?
(Select 3)
- A . Fabric Switching Engine
- B . Right Control Panel
- C . Chassis Luggage Tag
- D . LCD Panel
- E . Management Module
What type of connection is used by QuickSync 2?
- A . Bluetooth
- B . NFC
- C . QuickAssist
- D . LTE
Which is a logical resource in SmartFabric?
- A . storage
- B . servers
- C . uplinks
- D . switches
Which feature requires an iDRAC Enterprise license for a compute sled on a PowerEdge MX7000 chassis?
- A . Remote file share
- B . iDRAC Service Module
- C . Last Crash Screen
- D . Storage Management
Where are the diagnostic LEDs located on a PowerEdge MX750c compute sled?
- A . Front of the sled after removing the bottom two drives
- B . Middle of the system board with the top of the cover removed
- C . Located on the back of the sled
- D . Front of the sled after removing the top two drives
Which uplink configuration combination of the Top of the Rack Switch and the MX7000 Management Module is supported?
- A . 100 Mbps (Auto negotiation OFF) and Auto negotiation OFF
- B . 100 Mbps (Auto negotiation ON) and Auto negotiation OFF
- C . 100 Mbps (Auto negotiation OFF) and Auto negotiation ON
What is the minimum required HW configuration on the PowerEdge MX840c to POST?
- A . 1 processor in socket CPU1
1 memory module installed in socket A1
1 mezzanine card installed in Mezz A1 slot - B . 1 processor in each CPU socket
1 memory module installed per CPU socket
1 mezzanine card installed per CPU Mezz slot - C . 1 processor in any CPU socket
1 memory module installed in any socket
1 mezzanine card installed in any Mezz slot - D . 1 processor in socket CPU2
1 memory module installed in socket B1
1 mezzanine card installed in Mezz B1 slot