Fortinet FCP_FWF_AD-7.4 Übungsprüfungen
Zuletzt aktualisiert am 27.04.2025- Prüfungscode: FCP_FWF_AD-7.4
- Prüfungsname: FCP - Secure Wireless LAN 7.4 Administrator
- Zertifizierungsanbieter: Fortinet
- Zuletzt aktualisiert am: 27.04.2025
What steps are necessary for provisioning and managing FortiAP devices using a FortiGate integrated wireless controller? (Select all that apply)
- A . Create and apply a FortiAP profile
- B . Assign a VLAN to each SSID
- C . Configure a tunnel mode for all wireless networks
- D . Preauthorize APs on the FortiGate
Which modulation scheme offers extremely high throughput (EHT) in 802.11be technology?
- A . Direct sequence spread spectrum
- B . Binary phase-shift keying
- C . Orthogonal frequency division multiplexing
- D . Quadrature amplitude modulation
What might cause wireless performance issues?
- A . Incorrectly set clock on the wireless controller
- B . Interference from other electronic devices
- C . A mismatch in wired network settings
- D . AP located too close to client devices
Refer to the exhibit.
What does the asterisk (*) symbol beside the channel mean?
- A . Indicates channels that are subject to dynamic frequency selection (DFS) regulations
- B . Indicates channels that cannot be used because of regulatory channel restrictions
- C . Indicates channels that will be scanned by the Wireless Intrusion Detection System (WIDS)
- D . Indicates channels that can be used only when Radio Resource Provisioning is enabled
Which two phases are part of the process to plan a wireless design project? (Choose two.)
- A . Project information phase
- B . Hardware selection phase
- C . Site survey phase
- D . Installation phase
What is the primary function of FortiPlanner?
- A . Wireless network threat analysis
- B . Predictive modeling for wireless network planning
- C . FortiGate device configuration
- D . Management of FortiAP devices
A tunnel mode wireless network is configured on a FortiGate wireless controller.
Which task must be completed before the wireless network can be used?
- A . Security Fabric and HTTPS must be enabled on the wireless network interface
- B . The wireless network interface must be assigned a Layer 3 address
- C . The wireless network to Internet firewall policy must be configured
- D . The new network must be manually assigned to a FortiAP profile.
Which action would be most appropriate when a rogue AP is detected?
- A . Update the firmware of the rogue AP.
- B . Increase the number of active APs in the area.
- C . Suppress or quarantine the rogue AP.
- D . Assign a new SSID to the rogue AP.
Which actions can be taken to provision and manage FortiAP devices using the FortiGate wireless controller? (Select all that apply)
- A . Create and apply FortiAP profiles
- B . Enable SSID hiding
- C . Configure advanced wireless settings
- D . Implement VLAN load-balancing