NACE NACE-CIP2-001 Übungsprüfungen
Zuletzt aktualisiert am 26.04.2025- Prüfungscode: NACE-CIP2-001
- Prüfungsname: Coating Inspector Level 2
- Zertifizierungsanbieter: NACE
- Zuletzt aktualisiert am: 26.04.2025
Question #1
A failure caused by applying a coating too thinly is known as
- A . failure to cure.
- B . chalking.
- C . cracking.
- D . pinholes.
Question #2
A reinforced coating is
- A . equally resistant to movement and impact as a non-reinforced coating.
- B . equally resistant to abrasion and impact as a non-reinforced coating.
- C . less resistant to movement, abrasion, and impact than a non-reinforced coating.
- D . more resistant to movement, abrasion, and impact than a non-reinforced coating.
Question #3
When working with someone who is very concerned about Stability and maintaining adherence to the status-quo, the Inspector should try to:
- A . Implement immediate to get them motivated
- B . Give them as much advance notice as possible about upcoming changes
- C . Challenge their value to the team and try to get them out of their comfort zone
- D . Make sure they are the center of attention in all site meetings
Question #4
Pre-cleaning of work pieces will NOT remove
- A . snow, ice or water.
- B . oil or grease.
- C . dirt.
- D . mill scale.
Question #5
NACE International Standards are developed by:
- A . Government mandates
- B . International mandates
- C . Standard committees
- D . Regional mandates
Question #6
Individuals conducting Coating Surveys should:
- A . Always be NACE Level 3 Certified Inspectors
- B . Always be NACE or SSPC Protective coating Specialists
- C . Always be experienced Specification Writers
- D . Always be trained and experienced Coating Industry
Question #7
When observing fabrication defects the NACE Inspector should:
- A . Require they be corrected prior to coating
- B . Consult the specification to determine how they should be treated
- C . Stop the job immediately
- D . Write an NCR and call the fabricator
Question #8
The Concrete Repair Institute’s comparators can be used to assess:
- A . Surface cleanliness prior to coating
- B . Surface profile prior to coating
- C . Contamination levels prior to coating
- D . Compressive and tensile strength prior to coating
Question #9
Measuring methyl ethyl ketone (MEK) resistance of ethyl silicate inorganic zinc-rich primers by solvent rub requires
- A . 25 single rubs with a saturated cloth.
- B . 35 single rubs with a saturated cloth.
- C . 50 double rubs with a saturated cloth.
- D . 25 double rubs with a saturated cloth.
Question #10
Inspection and Test Plans are provided to:
- A . Outline the inspection steps, sequencing and pass/fail criteria
- B . So the Inspector doesn’t have to read the entire specification
- C . To supersede the requirements of the product data sheets
- D . So the contractor has a single document to reference