NACE NACE-CIP2-001 Übungsprüfungen
Zuletzt aktualisiert am 26.04.2025- Prüfungscode: NACE-CIP2-001
- Prüfungsname: Coating Inspector Level 2
- Zertifizierungsanbieter: NACE
- Zuletzt aktualisiert am: 26.04.2025
The main reason dehumidification is used during coating operations is to
- A . control the environment
- B . reduce the possibility of missing the recoat window.
- C . allow the contractor to guarantee the completion date.
- D . avoid repetitive blasting/coating operations.
When performing inspection in accordance with ASTM D 4138 the Inspector will use:
- A . A set of 14 pencils of varying hardness
- B . A destructive paint inspection Tooke gauge
- C . A mechanical adhesion tester
- D . A hardness tester
NACE No.13/ SSPC 6 identifies the use of:
- A . Abrasive blasting only
- B . Watterjetting only
- C . Steam cleaning only
- D . Various methods of cleaning
The standards defining surface cleanliness achieved by centrifugal blast cleaning are:
- A . Different than air blast cleaning
- B . The same as air blast cleaning
- C . Slightly different to air blast cleaning
- D . Comparable to air blast cleaning
External coatings applied to buried pipelines are generally tested for:
- A . Gloss level
- B . Chalking resistance
- C . Cathodic disbondment
- D . Solvent resistance
As a NACE Level 2 Inspector, NACE clearly indicates that you ate qualified to independently produce final documentation for a shop project.
- A . True
- B . False
Galvanizing performs best in which of the following exposures:
- A . pH below 4
- B . pH above 12
- C . pH between 5-10
- D . pH of 13
All of these are advantages of using repair patches EXCEPT
- A . special tools or equipment are required.
- B . excellent abrasion resistance.
- C . inert to common acids, alkalis, and solvents.
- D . barrier to moisture and corrosion.
As a NACE Level 2 Inspector on a field job; prior to submission your documentation should always reviewed and approved by:
- A . A NACE Protective Coating Specialist
- B . A NACE Level 1 Inspector
- C . Another NACE Level 2 Inspector
- D . A NACE Level 3 Inspector
When performing a hardness test on a coating which has elastic properties the inspector is likely to likely to observe:
- A . A very high reading
- B . A very low reading
- C . Cold flow or creep
- D . No difference from any other coating