Network Appliance NS0-163 Übungsprüfungen
Zuletzt aktualisiert am 27.04.2025- Prüfungscode: NS0-163
- Prüfungsname: NetApp Certified Data Administrator, ONTAP
- Zertifizierungsanbieter: Network Appliance
- Zuletzt aktualisiert am: 27.04.2025
Node 1 in a clustered pair detects that it has lost connectivity to one of its disk shelves. Node 1 is still up, but it cannot see one of its disk shelves. However, the partner node, Node 2, can see all of Node 1s disk shelves.
Which one of the following features will cause Node 2 to monitor this error condition for a period of three minutes (by default), and then forcibly take over Node 1 if the error condition persists?
- A . Takeover on panic
- B . Negotiated Fail Over
- C . Auto enable of giveback
- D . cf.quickloop.enable
Which command displays the disk ownership for both CPU modules in a FAS270C appliance?
- A . disk show-v
- B . disk display-r
- C . disk own -s
- D . vol status Cr
In a fabric-attached MetroCluster, hardware disk ownership by a node is determined by which two factors (Choose two.)
- A . the system ID of the controller
- B . what types of ports are on the HBA
- C . the location of the HBA or onboard port
- D . what types of disks are used in the cluster
- E . how the disks are configured by the administrator
- F . which switch ports the controller and disks are connected to
When you are setting up SnapMirror, which one of the following is not a replication pre-requisite?
- A . SnapMirror must be licensed for each storage appliance.
- B . The source volume must be offline.
- C . If you are replicating a volume, you must create a restricted volume to be used as the SnapMirror destination volume.
- D . The capacity of the SnapMirror destination must be greater than or equal to the capacity of the source.
Which two commands could be used if the cf giveback command foils? (Choose 2)
- A . cf giveback -force
- B . cf giveback -f
- C . cf forceeiveback -f
- D . cf forceeiveback
Fill in the blank for the following statement using the best answer from the choices that follow. A snapshot is a frozen, read-only image of the entire Data ONTAP file system that reflects the state of the____________at the time the snapshot was created.
- A . qtrees
- B . directory
- C . file system
- D . storage appliance
Which statement describes the results of the snapmirror resync command?
- A . Resynchronization finds the newest common snapshot shared by the two volumes or qtrees, and removes all newer information on the storage appliance on which the command is run.
- B . Resynchronization made. cause the loss of all data written to the destination after the original base snapshot was
- C . Resynchronization. update the snapshot on the source filer.
- D . Resynchronization. update the snapshot on the destination filer.
Due to the sensitive nature of AutoSupport messages, what transport protocol should a storage administrator configure?
- A . HTTPS
- B . HTTP
- C . SFTP
- D . SMTP
Which ONTAP feature will allow WORM and non-WORM volumes in the same aggregate?
- A . NetApp Aggregate Encryption
- B . Unified Aggregate
- C . SnapLock Enterprise
- D . SnapLock Compliance
Snapshot copies for SnapLock volumes are deleted automatically according to the retention count set in the Snapshot schedule.
- A . True
- B . False